DCS | MMC PROGRAMS | ||||
COMBINED PROGRAMMING MANUAL | NOVEMBER 2001 | ||||
|
|
|
|
|
|
|
|
|
|
|
|
MMC: 810 HALT PROCESSING
DCS
3
CI
3
CII
3
816
3
408i
7
408
7
Used only in the event that all data processing needs to be stopped in either a single cabinet or slot, or in the entire system. The procedure differs slightly between systems.
Note: You do not need to enable system programming (MMC 800) in order to run this program but you will still require the technician’s passcode.
PROGRAM KEYS |
|
UP & DOWN | Used to scroll through options |
KEYPAD | Used to enter selections |
SOFT KEYS | Move cursor left and right |
SPEAKER | Used to store data and advance to next MMC |
ANS/RLS | Used to select ALL |
nDCS PROCEDURE
ACTION
1.Open programming and select 810 Display shows
2a. Enter cabinet selection via dial keypad
OR
Press UP or DOWN key to make selection and press RIGHT soft key to advance cursor
DISPLAY
HALT/PROCESSING C:ALL S:ALL→PROC
HALT/PROCESSING
C:3 S:ALL→PROC
2b. Press ANS/RLS to select all cabinets and all slots
3.Enter slot number via dial keypad
OR
Press UP or DOWN key to make selection and press RIGHT soft key to advance cursor
4.Enter 1 for HALT or 0 to PROC OR
Press UP or DOWN key to make selection and press RIGHT soft key to enter data and return to step 2
5.Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
HALT/PROCESSING C:ALL S:ALL→PROC
HALT/PROCESSING
C:3 | S:5 →PROC |
HALT/PROCESSING
C:3 | S:5 →HALT |
MMC 810 (Page 1 of 2)
