Samsung DCS-408I manual Programming Procedures

DCS	INTRODUCTION
COMBINED PROGRAMMING MANUAL	NOVEMBER 2001

The 6, 12 or 24 extra programmable keys can be set up to perform specific functions when pressed during normal operation. During programming, some of these keys also perform other specific functions. This is described in the individual MMC program pro- cedure where applicable.

1.5Programming Procedures

1.5.1Precautions When Programming

∙The keyset must be on-hook (handset down) to allow programming.

∙Programming is available on any digital keyset with an LCD.

∙Programming is available only on digital telephones (not analogue ones).

∙If ‘INVALID DATA’ appears in the LCD while programming, you should re-enter the correct data.

∙When you have successfully completed an entry, the LCD automatically changes for the next step.

∙Programming halts if you have not pressed a key for a certain period of time (30 sec- onds by default, but this can be changed).

∙Programming halts if you pick up the handset while programming.

∙If you pick up the handset while programming, or the telephone plug is pulled out, any new data shown in the LCD are saved.

IMPORTANT

When installing and programming a ‘default’ system

for the first time:

The system requires that you select the correct software version for your country (e.g. by selecting “UK”) before you can do any other programming via either a key- phone (KMMC programming) or a PC (PCMMC programming).

To select the country:

1.Press the TRSF key.

2.Enter 800 followed by the default passcode (4321)

The system sounds a warning and displays on the keyset:

ENABLE TECH. PROG

SELECT COUNTRY

Use the VOLUME Up/Down keys to select the country and press the RIGHT soft key. The keyset displays:

DEFAULTING SYSTM

ARE YOU SURE? NO

Use the VOLUME Up/Down keys to select YES and press the RIGHT soft key. When defaulted to the correct version, you can open programming as described next. The country version selected can be changed in MMC 812, Select Country.

1-4