SMC Networks SMC6824M manual Showing Port Statistics, 139

PORT CONFIGURATION

CLI - This example sets the rate limit for input and output traffic passing through port 1 to 60 Mbps.

Console(config)#interface ethernet 1/1	4-171
Console(config-if)#rate-limit input 60	4-187
Console(config-if)#rate-limit output 60	4-187
Console(config-if)#

Showing Port Statistics

You can display standard statistics on network traffic from the Interfaces Group and Ethernet-like MIBs, as well as a detailed breakdown of traffic based on the RMON MIB. Interfaces and Ethernet-like statistics display errors on the traffic passing through each port. This information can be used to identify potential problems with the switch (such as a faulty port or unusually heavy loading). RMON statistics provide access to a broad range of statistics, including a total count of different frame types and sizes passing through each port. All values displayed have been accumulated since the last system reboot, and are shown as counts per second. Statistics are refreshed every 60 seconds by default.

Note: RMON groups 2, 3 and 9 can only be accessed using SNMP management software such as SMC EliteView.

Table 3-11 Port Statistics
Parameter	Description
Interface Statistics
Received Octets	The total number of octets received on the interface,
	including framing characters.
Received Unicast Packets	The number of subnetwork-unicast packets delivered
	to a higher-layer protocol.
Received Multicast Packets	The number of packets, delivered by this sub-layer to
	a higher (sub-)layer, which were addressed to a
	multicast address at this sub-layer.
Received Broadcast	The number of packets, delivered by this sub-layer to
Packets	a higher (sub-)layer, which were addressed to a
	broadcast address at this sub-layer.

3-139