SMC Networks SMC6824M manual Line Commands, Command Function Mode, Password-thresh command

COMMAND LINE INTERFACE

Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the switch’s serial port. These commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).

Table 4-5 Line Commands

Command	Function	Mode	Page
line	Identifies a specific line for configuration and	GC	4-14
	starts the line configuration mode
login	Enables password checking at login	LC	4-15
password	Specifies a password on a line	LC	4-16
timeout login	Sets the interval that the system waits for a login	LC	4-17
response	attempt
exec-timeout	Sets the interval that the command interpreter	LC	4-18
	waits until user input is detected
password-thresh	Sets the password intrusion threshold, which	LC	4-19
	limits the number of failed logon attempts
silent-time*	Sets the amount of time the management console	LC	4-20
	is inaccessible after the number of unsuccessful
	logon attempts exceeds the threshold set by the
	password-thresh command
databits*	Sets the number of data bits per character that are	LC	4-20
	interpreted and generated by hardware
parity*	Defines the generation of a parity bit	LC	4-21
speed*	Sets the terminal baud rate	LC	4-22
stopbits*	Sets the number of the stop bits transmitted per	LC	4-23
	byte
disconnect	Terminates a line connection	PE	4-23
show line	Displays a terminal line's parameters	NE,	4-24
		PE

* These commands only apply to the serial port.

4-13