SMC Networks SMC6824M manual 170

CONFIGURING THE SWITCH

-Learning - Port has transmitted configuration messages for an interval set by the Forward Delay parameter without receiving contradictory information. Port address table is cleared, and the port begins learning addresses.

-Forwarding - Port forwards packets, and continues learning addresses.

•Trunk12 – Indicates if a port is a member of a trunk.

The following interface attributes can be configured:

•Spanning Tree – Enables/disables STA on this interface. (Default: Enabled)

•Priority – Defines the priority used for this port in the Spanning Tree Protocol. If the path cost for all ports on a switch are the same, the port with the highest priority (i.e., lowest value) will be configured as an active link in the Spanning Tree. This makes a port with higher priority less likely to be blocked if the Spanning Tree Protocol is detecting network loops. Where more than one port is assigned the highest priority, the port with lowest numeric identifier will be enabled.

-Default: 128

-Range: 0-240, in steps of 16

•Path Cost – This parameter is used by the STA to determine the best path between devices. Therefore, lower values should be assigned to ports attached to faster media, and higher values assigned to ports with slower media. (Path cost takes precedence over port priority.) Note that when the Path Cost Method is set to short (page 4-212),the maximum path cost is 65,535.

-Range:

-Ethernet: 200,000-20,000,000

-Fast Ethernet: 20,000-2,000,000

-Gigabit Ethernet: 2,000-200,000

-Default:

-Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000;

trunk: 500,000

-Fast Ethernet – Half duplex: 200,000; full duplex: 100,000;

trunk: 50,000

-Gigabit Ethernet – Full duplex: 10,000; trunk: 5,000

12.STA Port Configuration only

3-170