SMC Networks SMC6824M manual 156, Snmp-server host

SNMP COMMANDS

snmp-server host

This command specifies the recipient of a Simple Network Management Protocol notification operation. Use the no form to remove the specified host.

Syntax

snmp-server host host-addr[inform [retry retries timeout seconds]] community-string[version {1 2c 3 {auth noauth priv} [udp-port port]}

no snmp-server host host-addr

•host-addr- Internet address of the host (the targeted recipient). (Maximum host addresses: 5 recipient destination IP address entries)

•inform - Notifications are sent as inform messages. Note that this option is only available for version 2c and 3 hosts. (Default: traps are used)

-retries - The maximum number of times to resend an inform message if the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)

-seconds - The number of seconds to wait for an acknowledgment before resending an inform message. (Range: 0-2147483647 centiseconds; Default: 1500 centiseconds)

•community-string- Password-like community string sent with the notification operation to SNMP V1 and V2c hosts. Although you can set this string using the snmp-server host command by itself, we recommend that you define this string using the snmp-server community command prior to using the snmp-server host command. (Maximum length: 32 characters)

•version - Specifies whether to send notifications as SNMP Version 1, 2c or 3 traps. (Range: 1, 2c, 3; Default: 1)

-auth noauth priv - This group uses SNMPv3 with authentication, no authentication, or with authentication and privacy. See “Simple Network Management Protocol” on page 3-45for further information about these authentication and encryption options.

•port - Host UDP port to use. (Range: 1-65535; Default: 162)

4-156