SMC Networks SMC6824M manual Mst vlan, MST Configuration

COMMAND LINE INTERFACE

Related Commands

mst vlan (4-215) mst priority (4-216) name (4-217) revision (4-218)max-hops(4-218)

mst vlan

This command adds VLANs to a spanning tree instance. Use the no form to remove the specified VLANs. Using the no form without any VLAN parameters to remove all VLANs.

Syntax

[no] mst instance_id vlan vlan-range

•instance_id - Instance identifier of the spanning tree. (Range: 0-4094)

•vlan-range- Range of VLANs. (Range: 1-4093)

Default Setting

none

Command Mode

MST Configuration

Command Usage

•Use this command to group VLANs into spanning tree instances. MSTP generates a unique spanning tree for each instance. This provides multiple pathways across the network, thereby balancing the traffic load, preventing wide-scale disruption when a bridge node in a single instance fails, and allowing for faster convergence of a new topology for the failed instance.

•By default all VLANs are assigned to the Internal Spanning Tree (MSTI 0) that connects all bridges and LANs within the MST region. This switch supports up to 58 instances. You should try to group VLANs which cover the same general area of your network. However, remember that you must configure all bridges within the same MSTI Region (page 4-217)with the same set of instances, and the same instance (on each bridge) with the same set of VLANs. Also, note that RSTP treats each

4-215