SMC Networks SMC6824M manual Configuring Snmp Trap Managers

CONFIGURING THE SWITCH

-Retry times – The maximum number of times to resend an inform message if the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)

•Enable Authentication Traps3 – Issues a notification message to specified IP trap managers whenever authentication of an SNMP request fails. (Default: Enabled)

•Enable Link-up and Link-down Traps3 – Issues a notification message whenever a port link is established or broken. (Default: Enabled)

Web – Click SNMP, Configuration. Enter the IP address and community string for each management station that will receive trap messages, specify the UDP port, trap version, trap security level (for v3 clients), trap inform settings (for v2c/v3 clients), and then click Add. Select the trap types required using the check boxes for Authentication and Link-up/down traps, and then click Apply.

Figure 3-24 Configuring SNMP Trap Managers

CLI – This example adds a trap manager and enables authentication traps.

Console(config)#snmp-server host 10.1.19.23 inform private
version 2c udp-port 160	4-156
Console(config)#snmp-server enable traps authentication	4-159
Console(config)#

3.These are legacy notifications and therefore when used for SNMP Version 3 hosts, they must be enabled in conjunction with the corresponding entries in the Notification View (page 3-61).

3-52