SMC Networks SMC6824M manual 200, Configuring Private Vlan Interfaces

CONFIGURING THE SWITCH

CLI – This example shows the switch configured with primary VLAN 5 and secondary VLAN 6. Port 3 has been configured as a promiscuous port and mapped to VLAN 5, while ports 4 and 5 have been configured as a host ports and associated with VLAN 6. This means that traffic for port 4 and 5 can only pass through port 3.

Console#show vlan private-vlan			4-247
Primary	Secondary	Type	Interfaces
--------	-----------	----------	--------------------------------
5	6	primary	Eth1/ 3
5		community	Eth1/ 4 Eth1/ 5
Console#

Configuring Private VLAN Interfaces

Use the Private VLAN Port Configuration and Private VLAN Trunk Configuration menus to set the private VLAN interface type, and associate the interfaces with a private VLAN.

Command Attributes

•Port/Trunk – The switch interface.

•PVLAN Port Type – Sets the private VLAN port types.

-Normal – The port is not configured into a private VLAN.

-Host – The port is a community port and can only communicate with other ports in its own community VLAN, and with the designated promiscuous port(s).

-Promiscuous – A promiscuous port can communicate with all interfaces within a private VLAN.

•Primary VLAN – Conveys traffic between promiscuous ports, and between promiscuous ports and community ports within the associated secondary VLANs. If PVLAN type is “Promiscuous,” then specify the associated primary VLAN. For “Host” type, the Primary VLAN displayed is the one to which the selected secondary VLAN has been associated.

•Secondary VLAN – On this switch, all secondary VLANs are community VLANs. A community VLAN conveys traffic between community ports, and from community ports to their designated

3-200