SMC Networks SMC6824M manual Configuring SNMPv3 Groups

SIMPLE NETWORK MANAGEMENT PROTOCOL

CLI – Use the snmp-server user command to configure a new user name and assign it to a group.

Console(config)#snmp-server user mark group r&d remote
192.168.1.19 v3 auth md5 greenpeace priv des56 einstien	4-167
Console(config)#exit
Console#show snmp user	4-169

No user exist.

SNMP remote user

EngineId: 80000000030004e2b316c54321

User Name: mark

Authentication Protocol: none

Privacy Protocol: none

Storage Type: nonvolatile

Row Status: active

Console#

Configuring SNMPv3 Groups

An SNMPv3 group sets the access policy for its assigned users, restricting them to specific read, write, and notify views. You can use the pre-defined default groups or create new groups to map a set of SNMP users to SNMP views.

Command Attributes

•Group Name – The name of the SNMP group. (Range: 1-32 characters)

•Model – The group security model; SNMP v1, v2c or v3.

•Level – The security level used for the group:

-noAuthNoPriv – There is no authentication or encryption used in SNMP communications.

-AuthNoPriv – SNMP communications use authentication, but the data is not encrypted (only available for the SNMPv3 security model).

-AuthPriv – SNMP communications use both authentication and encryption (only available for the SNMPv3 security model).

•Read View – The configured view for read access. (Range: 1-64 characters)

•Write View – The configured view for write access. (Range: 1-64 characters)

3-61