SMC Networks SMC6824M manual 178, CLI This example sets the Mstp attributes for port

CONFIGURING THE SWITCH

when the Path Cost Method is set to short (page 3-63), the maximum path cost is 65,535.

By default, the system automatically detects the speed and duplex mode used on each port, and configures the path cost according to the values shown below. Path cost “0” is used to indicate auto-configuration mode.

•Range –

-Ethernet: 200,000-20,000,000

-Fast Ethernet: 20,000-2,000,000

-Gigabit Ethernet: 2,000-200,000

•Default –

-Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000;

trunk: 500,000

-Fast Ethernet – Half duplex: 200,000; full duplex: 100,000;

trunk: 50,000

-Gigabit Ethernet – Full duplex: 10,000; trunk: 5,000

Web – Click Spanning Tree, MSTP, Port Configuration or Trunk Configuration. Enter the priority and path cost for an interface, and click Apply.

Figure 3-75 MSTP Port Configuration

CLI – This example sets the MSTP attributes for port 4.

Console(config)#interface ethernet 1/4	4-171
Console(config-if)#spanning-tree mst port-priority 0	4-225
Console(config-if)#spanning-tree mst cost 50	4-224
Console(config-if)

3-178