SMC Networks SMC6824M manual Snmp-server user, Default Setting

COMMAND LINE INTERFACE

snmp-server user

This command adds a user to an SNMP group, restricting the user to a specific SNMP Read and a Write View. Use the no form to remove a user from an SNMP group.

Syntax

snmp-server user username groupname [remote ip-address] {v1 v2c v3 [encrypted] [auth {md5 sha} auth-password[priv des56 priv-password]]

no snmp-server user username {v1 v2c v3 remote}

•username - Name of user connecting to the SNMP agent. (Range: 1-32 characters)

•groupname - Name of an SNMP group to which the user is assigned. (Range: 1-32 characters)

•remote - Specifies an SNMP engine on a remote device.

•ip-address- The Internet address of the remote device.

•v1 v2c v3 - Use SNMP version 1, 2c or 3.

•encrypted - Accepts the password as encrypted input.

•auth - Uses SNMPv3 with authentication.

•md5 sha - Uses MD5 or SHA authentication.

•auth-password- Authentication password. Enter as plain text if the encrypted option is not used. Otherwise, enter an encrypted password. (A minimum of eight characters is required.)

•priv des56 - Uses SNMPv3 with 56-bit DES data encryption.

•priv-password- Privacy password. Enter as plain text if the encrypted option is not used. Otherwise, enter an encrypted password.

Default Setting

None

Command Mode

Global Configuration

Command Usage

•The SNMP engine ID is used to compute the authentication/privacy digests from the password. You should therefore configure the engine

4-167