SMC Networks SMC6824M manual 256, Switchport priority default

PRIORITY COMMANDS

Command Usage

WRR controls bandwidth sharing at the egress port by defining scheduling weights.

Example

The following example shows how to assign WRR weights of 1, 3, 5 and 7 to the CoS priority queues 0, 1, 2 and 3:

Console(config)#queue bandwidth 1 3 5 7

Console(config)#

Related Commands

show queue bandwidth (4-259)

switchport priority default

This command sets a priority for incoming untagged frames. Use the no form to restore the default value.

Syntax

switchport priority default default-priority-idno switchport priority default

default-priority-id- The priority number for untagged ingress traffic. The priority is a number from 0 to 7. Seven is the highest priority.

Default Setting

The priority is not set, and the default value for untagged frames received on the interface is zero.

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

•The precedence for priority mapping is IP Port, IP Precedence or IP DSCP, and default switchport priority.

•The default priority applies for an untagged frame received on a port set to accept all frame types (i.e, receives both untagged and tagged frames). This priority does not apply to IEEE 802.1Q VLAN tagged frames. If

4-256