Performance Tests
Vertical | CH1 and CH2 |
Coupling | DC |
Scale | 0.23V/div. |
Input Impedance | 503Ω |
Horizontal |
|
Sweep | 5003μs/div. |
Trigger |
|
Source | CH1 |
Coupling | DC |
Slope | Positive |
Level | 03mV |
Mode | Auto |
Output | Off |
2.Select the master AWG2005 waveform file and set master AWG2005 controls:
a.Initialize master AWG2005 controls: Push UTILITYMiscCon- fig...Reset to FactoryO.K.
b.Load waveform file: Load the CNTRL_IN.WFM file only to the master AWG2005 using the performance check disk. For details on how to load a file, see the Instruction for Operation in the section 2.
c.Set waveform file:
Push SETUPWaveform Sequence, if necessary, to select a waveform file for CH1. Waveform Sequence toggles between the CH1 files (upper list) and the CH2 files (lower list).
Turn the general purpose knob to display the list of waveform files and highlight the SLAVE.WFM file.
Push ENTER to select the file.
Push MODETriggered.
Press the bottom Configure button to select Master.
3.Select the slave AWG2005 waveform file and set slave AWG2005 con trols:
a.Initialize slave AWG2005 controls: Push UTILITYMiscCon- fig...Reset to FactoryO.K.
b.Select waveform file:
Push SETUPWaveform Sequence, if necessary, to select a waveform file for CH1. Waveform Sequence toggles between the CH1 files (upper list) and the CH2 files (lower list).
Turn the general purpose knob to highlight the SLAVE.WFM file.
Push ENTER to select the file.
Push MODECont.
AWG2005 Service Manual | 445 |