Tektronix AWG2005 Check Cont Mode, Operating Mode Checks, Procedure:, Prerequisites:, Equipment Required:, Electrical Characteristic Checked: Operating modes, Continuous, on

Performance Tests

Table.403:/File List for Performance Check Disk (Cont.)

			EDIT Menu			SETUP Menu
No.	File Name									Usage
		Wfm		Wfm
					Clock	Operation	Filter	Ampl	Offset
		Shape		Point
14	MS_SL.WFM			9200	9918MHz	Normal	Through	18V	08V	Master-Slave
										Operation
										Check (Op:
										tional Check)
15	DIGI_OUT.WFM			4096	9918MHz	Normal	Through	18V	08V	DIGITAL
										DATA OUT
										Check
										(Option 04)

Operating Mode Checks

These procedures check operation of the Cont, Triggered, Gated, Waveform Advance, and Autostep modes.

Check Cont Mode

Electrical Characteristic Checked: Operating modes, Continuous, on

page81:5.

Equipment Required: A 508Ω coaxial cable and an oscilloscope.

Prerequisites: The AWG2005 must meet the prerequisites listed on page￿4:7.

Procedure:

1.Install the test hookup and set test equipment controls:

a.Hook up the oscilloscope: Connect the AWG2005 CH1 output connector through the coaxial cable to the CH1 vertical input con: nector on the oscilloscope (see Figure 4:3).

AWG2005 Oscilloscope

AWG2005

Figure 403:/Cont Mode Initial Test Hookup

4￿12 Performance Verification