Tektronix AWG2005 EMC, CAT, CAT, CAT, 120, service, Category, Category, EN60555?2, Approvals, EN 50081?1, EN 50082?1, Low Voltage, Communities:, Pollution Degree

Characteristics

	Certifications and compliances

Category	Standards or description

EC Declaration of Conformity -	Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
EMC	demonstrated to the following specifications as listed in the Official Journal of the European
	Communities:
	EMC Directive 89/336/EEC:
	EN 55022		Class B Radiated and Conducted Emissions
	EN 50081?1	Emissions:
	EN60555?2		AC Power Line Harmonic Emissions
	EN 50082?1	Immunity:
	IEC801?2		Electrostatic Discharge Immunity
	IEC801?3		RF Electromagnetic Field Immunity
	IEC801?4		Electrical Fast Transient/Burst Immunity

Australian/New Zealand	Complies with EMC provision of Radio-communications Act per the following standard:
declaration of Conformity ? EMC
	AS/NZS 2064.1/2		Industrial, Scientific, and Medical Equipment: 1992

EC Declaration of Conformity -	Compliance was demonstrated to the following specification as listed in the Official Journal of the
Low Voltage	European Communities:
	Low Voltage Directive 73/23/EEC, amended by 93/68/EEC
	EN 61010?1/A1:1992		Safety requirements for electrical equipment for
			measurement, control and laboratory use.

Approvals	Complies with the following safety standards:
	UL3111-1, First Edition		Standard for electrical measuring and test equipment.
	CAN/CSA C22.2 No.1010.1?92 Safety requirements for electrical equipment for
			measurement, control and laboratory use.

Installation Category Description	Terminals on this product may have different installation over-voltage category designations. The
	installation categories are:
	Category	Examples of products in this category
	CAT III	Distribution?level mains usually permanently connected. Equipment at this
		level is typically in a fixed industrial location.
	CAT II	Local?level mains wall sockets. Equipment at this level includes appliances,
		portable tools, and similar products. Equipment is usually cord?connected.
	CAT I	Secondary signal level or battery operated circuits of electronic equipment.

Pollution Degree	A measure of the contaminates that could occur in the environment around and within a product.
	Typically the internal environment inside a product is considered to be the same as the external.
	Products should be used only in the environment for which they are rated.
	Pollution Degree 2		Normally only dry, nonconductive pollution occurs. Occasionally a
			temporary conductivity that is caused by condensation must be
			expected. This location is a typical office/home environment.
			Temporary condensation occurs only when the product is out of
			service.

120

Specifications