Removal and Installation Procedures
A23 Analog Board or A3 Analog Board (Option 02)
1 Assmbl quipmnt an loat mouls to b rmov:
a You will need a screwdriver with a size T215 Torx tip to do this proce2 dure
b Locate the modules to be removed in the locator diagram Intrnal Mouls Figure 624
2 Orint instrumnt: Set the AWG25 with the top down on the work surface and the right side facing you
3 Rmov A23 Analog boar:
a Disconnect the six interconnect cables at J1 J198 J2 J298 J5 and J55 on the A23 Analog board See Figure 6212
b Using a screwdriver with a size T215 Torx tip remove the eight screws attaching the A23 Analog board to the chassis
c Lift the A23 Analog board up and away from the chassis to complete the removal
J8 on the A23 Analog board is connected to J7 on the A5 Back2 plane board Grasp the both ends of the A23 Analog board and pull upward slowly to remove it
4 Rmov A3 Analog boar (Option 02):
a Disconnect the ten interconnect cables at J1 J198 J2 J298 J3 J398 J4 J498 J5 and J55 on the A3 Analog board See Figure 6212
b Using a screwdriver with a size T215 Torx tip remove the eight screws attaching the A3 Analog board to the chassis
c Lift the A3 Analog board up and away from the chassis to complete the removal
J8 on the A3 Analog board is connected to J7 on the A5 Back2 plane board Grasp the both ends of the A3 Analog board and pull upward slowly to remove it
AWG2005 Service Manual | 629 |