Tektronix AWG2005 manual 31

		Characteristics
	Electrical Characteristics
Characteristics	Description	Performance
		Test
	Operating Modes
Continuous		Check Cont
	Generates the waveform or sequence continuously.	Mode,
		page 4412.
Triggered	Output quiescent until triggered by an GPIB, external, or manual	Check Trig4
		gered Mode,
	trigger; then generates a waveform or sequence only one time.
		page 4414.
Gated	Same as Continuous mode, except waveforms or sequences	Check Gated
		Mode
	are output for the duration of the gated signal.
		page 4416.
Waveform Advance
Continuous	Continuously generates the waveform or sequence in the Se4	Check Wave4
		form Advance
	quence file; the next trigger advances to the next waveform/se4
		Mode,
	quence.
		page 4418.
Step	Output quiescent until triggered by an GPIB, external, or manual
	trigger; then generates the waveform/sequence in the Sequence
	file. When the scan count reaches its value, then stops output
	and waits for the next trigger.
Autostep
Continuous	Similar operation to the Waveform ￿dvance : Continuous, but	Check Auto4
	the Autostep file is used instead of the Sequence file and the	step Mode,
	output parameters (Amplitude, Offset, etc.) are changed.	page 4420.
Step	Similar operation to the Waveform ￿dvance : Step, but the Au4
	tostep file is used instead of the Sequence file and the output
	parameters (Amplitude, Offset, etc.) are changed.
Master	Provide the Clock and the Trigger to the Slave AWG2005 for the
	parallel operation.
Slave	Receive the Clock and the Trigger from the Master AWG2005 for
	the parallel operation.

￿WG￿￿￿￿ Service Manual 1￿5