Tektronix AWG2005 Cleaning Procedure￿,￿Exterior, Inspection￿,￿Interior

Inspection and Cleaning

Cleaning Procedure￿,￿Exterior

	WARNING
	To avoid potential electric shock hazard or damage to the
	AWG2005 circuits, do not allow any moisture inside the AWG2005
	during external cleaning; use only enough liquid to dampen the
	cloth or applicator.
	1￿ Remove loose dust on the outside of the AWG2￿￿5 with a lint free cloth￿
	2￿ Remove remaining dirt with a lint free cloth dampened in a general
	purpose detergent,and,water solution￿ Do not use abrasive cleaners￿
	3￿ Clean the light filter protecting the monitor screen with a lint,free cloth
	dampened with either ethyl alcohol or￿ preferably￿ a gentle general,pur,
	pose detergent,and,water solution￿
	Inspection￿,￿Interior
	To access the inside of the AWG2￿￿5 for inspection and cleaning￿ refer to
	the Removal and Installation Procedures in this section￿
	Inspect the internal portions of the AWG2￿￿5 for damage and wear￿ using
	Table 6,3 as a guide￿ Repair any defects immediately￿
		CAUTION
	To prevent damage from electrical arcing, ensure that circuit
	boards and components are dry before applying power to the
	AWG2005.
	Table)6+3:*Internal Inspection Check List
Item	Inspect For	Repair Action
Circuit boards	Loose￿ broken or corroded solder con,	Remove failed modules and replace
	nections￿ Burned circuit boards￿	with a new module￿
	Burned￿ broken￿ or cracked circuit,run
	plating￿
Resistors	Burned￿ cracked￿ broken blistered	Replace failed module and replace with
	condition￿	a new module￿
Solder connections	Cold solder or rosin joints￿	Resolder joint and clean with ethyl alco,
		hol￿

AWG￿￿￿5 Service Manual 6￿7