Tektronix AWG2005 Setting Output Parameters

Instructions for Operation

Destination

Source

Figure ￿%4:$LOAD Menu

Setting Output Parameters

3.Push the Device button along the bottom menu to select Disk. The menu in Figure 254 appears.

4.Select the Load All button along the side menu to load all files in the root directory on the disk into the AWG2005 internal (volatile) memory. Or, turn the general5purpose knob to highlight the file you want to load and select Load. The display indicates which file it is loading. When loading is complete, the clock disappears.

5.Push the floppy drive button and remove the disk from the floppy drive.

6.Push any button in the MENU column (other than LOAD/SAVE) to exit the menu.

The SETUP menu allows you to set various output parameters for outputting a waveform or sequence waveform. To set the output parameters, select a waveform or sequence file (that is already loaded into memory) as the active file.

When you select a file, the AWG2005 changes to the output parameters associated with the file and displays these parameters on the SETUP menu. If you modify the displayed output parameters and later save the file, the modified output parameters are saved with the file. (if the file is locked, you cannot modify the file contents.)

AWG￿￿￿5 Service Manual ￿2￿13