Removal ad Istallatio Procedures
Geeral Istructios
NOTE
Read these general instructions before removing a module.
First read the Summary of Procedures to understand how the procedures are organized. Then read quipment Required to find out the tools needed to remove and install modules.
To remove a module, begin by doing the Access Procedure (on page 6,13). By following the instructions in that procedure, you can remove the desired module without unnecessarily removing other modules.
Summary of Procedures
The Access Procedure on page 6,13 identifies the procedure for removing each module. These categories separate the procedures based on their location in the AWG2005.
Procedures for xternal Modules on page 6,16 describes how to remove modules without internal access to the AWG2005.
Procedures for nternal Modules on page 6,28 describes how to remove modules which require internal access to the AWG2005.
Equipmet Required
The removal of most modules in the AWG2005 requires only a screwdriver handle mounted with a size T,15, Torx screwdriver tip. Use this tool when, ever a procedure step instructs you to remove or install a screw, unless a different size screwdriver is specified in that step. The first step of a module procedure lists all equipment required to remove and reinstall the module.
610 | Maiteace |