Toshiba GD-1220 manual Transmission Trouble, Trouble Check Point

6 TROUBLESHOOTING

Transmission Trouble

Check the following points if you are having trouble sending originals. If you cannot rectify the trouble by checking these points, or trouble not listed below occurs, contact your service techni- cian.

Trouble	Check Point
“DIALING” or “COMMUNICATING”	When you are making a call using a handset to send a FAX, do
is not displayed even if the key is	replace the handset until after you press the key and you hear the
pressed in Direct Transmission	phone line switch to the machine.
Mode.	y Did you press the [FAX] button before beginning the Direct TX
	operation?
	y Is the modular cord disconnected?
	y Is the dial type set correctly?
	y Can you receive telephone calls?
	y Is there any problem at the remote fax? Check this with the
	party trying receive the original.
Originals are fed diagonally.	y Are the document feeder slides adjusted to the width of the orig-
	inal that you are sending?
	y Does the original that you are sending match the conditions of
	the original that is available for sending?
2 originals are fed together.	y Have you placed more than the maximum number of originals
	can be placed at one time? ( P.31 “Original size/Original
	scanning range”)
	y Does the original that you are sending match the conditions of
	original that is available for sending?
	y Have you pushed the originals into the feeder too hard?
The original is not being printed on	y Was the original placed correctly facing up?
the paper of the remote Fax even
though it has been sent.
Black lines are shown in the image	y Is the scanning area of the Reversing Automatic Document
that was sent.	Feeder clean? Clean it with a soft cloth.
Originals are not sent even if oper-	y Is the remote Fax compatible with your system? This system
ations are carried out normally.	supports G3 communications but not G2 or G4 communica-
	tions.
Originals cannot be sent overseas.	y Specify Quality TX and resend.

246 Troubleshooting