49

mm50

51

52

53

‘\

the number of the mailbox to receive the copied messages. A copy of messages sent

toa~withthisattributeinitsCOScanbesenttoasingiemaiEbox,a. Distribution List pilot number, or a Network mailbox. Refer to the Femurs Des&p& manud - CUSTOMIZATION.

AUTO-DELETE A COPIED MESSAGE

Used in conjunction with Attribute 48. Automatically deletes the message in the Original~andsendsittothemaiIbcarconfiguredintheprocessd~in

Attribute 48 Refer to the F’

Des+&

manual - CUSTOMIXIION,

STORE MESSAGES REDUNDANTLY

Used when two hard disk drives are installed and used for redundancy. Refer to the Feanut Dtzmiption manual - HARD DISK REDUND,WCY.

RECORD SPECIAL PURPOSE GREElING

‘Ilis feature is designed to be used with qxcific applications An example is recording long meetings so other employees may listen at a convenient time.

With this attribute assigned, recording is more tolerant to silence, talkoff, and

inadvertent DlMF keypad entries or amtent in voice.

*

The maximum amount of silence before the prompt “Recora%tgirpatmd ake to silence.. ))is controlled by System Parameter ll3. Normal silence before pause is 8 seconds. The maxim um for System Parameter ll3 is 4 minutes. If the silence limit is reached, the greeting is retained in the maiIbcnz as it was recorded, up to the point where silence began. Normal operation throws away a greqing ended by maximum silence and keeps the previously stored greeting. Since DTMF detection is disabled, recording is terminated only when q q is entered or the maximum time Iimit for silence has been reached. Refer to the Fearure Dex+xion manual -

CUSTOMIZATION.

DYNAMIC CALL BLOCKING (Call BlocJcing) (Assign to PORT only)

AIlows blocking to be determined by the call blocking value of the first mailbox dialed rather than the call blocking value of the port the call came in on. This frees the port to answer any incoming call, regardless of the call blocking value of the group being called.

This also enables CalI biocking to work with DID and E&M applications rather than blocking being applied on all ports so that DID/E&M caIls may be blccked.

The Dynamic CalI Blocking feature only works if the port call blocking value is 0 and the first mailbox being called has a calI blocking value other than 0. Any subsequent calls to mailboxes with a call blocking value of 0 are placed.

NO DELAY BETWEEN EACH OFFSITE MESSAGE WAITING CALL

In normal operation, the mailbox configuration parameter determines the amount of time to delay between placing Offsite Message Waiting calls (configured by using

Page 108
Image 108
Toshiba VP 300S manual Attribute 48 Refer to the F’ Des+, Customization, Record Special Purpose GREElING