Toshiba VP 300S manual HOW to Configure the Ports Table, Cos

17.3HOW TO CONFIGURE THE PORTS TABLE

Each port connected to a PBX extension can be comigured to handle calls differently. The following describes the valid or invalid entries for the POKI?3 Table fields.

EXTENSIONSDefines each PBX extension number connected to a Toshiba VP System port. A mailbox extension number caurmt be the same as a port extension number.

cos

ANSWER MODE

OUTCAU

TEST

The COS assigned to each port defies the feature attributes associated with that port.

COS also directs the Toshiba VP System to the SCHEDULB and INFORMATION Tables The SCHEDULE Table contains times and days to use INFORMATION Tables. The INFORMATION Tables include the company greeting, intercept mailbox, and other information for each

PO*-

qFor consistency and clarity, assign COS for ports from 127 in descending order and mailbox COS from 0 (zero) ascending order.

Must be either Primary Answer - AX, Secondary Answer - CX, or Message Center - MX

Defmes the ports allowed to place Message Waiting, Network Message andAlarmcaUs.

In most cases, allow all ports to make outcalls. When all ports are defined as YES, the Toshiba VP System only makes outcalls when no more than K of the ports are in use. This leaves ports available for incoming calls. If NO is defiedfor any ports, all ports defined as YES are used for outcalls, even when more than % are in use.

It is recommended NO be used only for special applications.

Allows the selftest routine to be enabled or disabled. Some PBXs have the capability of running diagnostics on their ports. The diagnostics may cause the Toshiba VP System’s selftest to fail and place the Toshiba

VP System port in TST mode, taking the port out of service. The port remains in TST mcde until selftest runs again and is able to put the port in senice, or until the system is restarted. In these cases, selftest can be disabled.

Lu- This problem has been identified on the Oki Discover III, and the Ericsson Prodigy. This field should be YES unless you have consulted with your technical support group.

B Using INSTALL

The following is the PORTS Table question, as asked during INSTALL.