Toshiba VP 300S manual Integration Cards

21-l 0 C o n f i g u r a t i o n Mamat

-

ports are idle. lf more than 32 ports are configured, the

VP 3lXldVP 300 makes outcalls when at least four ports are idle. .

VFor AT&T System 75 integrations, all ports defmed as YES are used for outcalls, with no restrictions

TESTEnter YES or NO to enable or disable the VP 3OOs/VP 300’s selftest

rOUthe.I'-

VFor message waiting notification or alarm outcalls, multiple calls cm be placed simultaneously. The Toshiba VP System places only one network outcall at a time.

nIntegration Cards

When configurmg the SIBTS Table for integration cards, the following information is require&

CARD TYPE	Enter the type of integration card - MlC.
INTEGRATION UNIT	Enter the unit on the integration card being configured - 1 or 2
LINE APPEARANCES	Enter 3 for Line Appearance. Enter the system port number or	‘I
	range of port numbers assigned as line appearances
MESSAGE WAITING	Enter 1 or 2 for Message Waiting Link. Enter Y@ or NO to specify
UNK	whether or not the link is to be used to light message waiting lamps.
DEFAULT	Enter YES or NO to specify which link is to perform system
	message waiting notification for COS not specifically listed.
	Currently, this field applies only to AT&T System 79Deftity Gl
	and AT&T System 8YDefmity G2 integrations.
	-..
	V Speci@ only one link in the entire system as DEFAULT

cos

Enter the Classes of Service for which the link is to perform message waiting notification. Currently, this field applies only to AT&T System 75IlIeftity Gl and AT&T System 85/Defmity G2 integrations

VSystem Parameter 170 - INTEGRATION ON/OFF LINK MUST MATCH, must be set to YES, for the DEFAULT and COS entries to take effect.