Removing the Entry Platen

1Remove the overdrive enclosure ' page 6(46.

2Disconnect the media(sensor cable from the main PCA (connector labeled MEDIA).

3Remove the indicated screw from the right side(plate.

Torx-15

1

4Remove the indicated two screws from the left side(plate.

Torx-15Torx-20

2

3

5Release the indicated entry(platen clips by pushing the bottom front corners of the entry platen up.

6Pull the entry platen horizontally out from the plotter.

￿￿￿￿￿￿m￿￿￿n￿￿ See the following procedure.

6(48 Removal￿and￿Replacement

C4699(90000