Reinstalling the front￿panel assembly: Insert the bottom of the assembly into the two indicated notches, inside the right end￿cover. Then firmly reinsert the top two tabs.

Notch

Push the front panel from the outside, to check whether it is correctly installed.

Reinstalling the right end￿cover: Before replacing the end￿cover, make sure that

aThe black plastic piece at the front end of the pinch￿arm linkage is correctly attached to the side￿plate.

bThe lever nut is positioned inside the slot on the black plastic piece.

Nut

Black plastic piece

Disconnecting the Front*Panel Assembly

1Remove the right end*cover ' page 6*10.

2On the main PCA, gently pull the front*panel connector clamp (FP) to the right to release the flat, white cable.

3Pull the cable easily out of the clamp, and release it from the clip on the side of the electronics module.

COVER

FP

Reassembling: The contact part of the cable faces down. Prevent tugging of the cable at the point of connection by leaving slack between the connector and the clip.

4Detach the top*cover*sensor cable from the COVER connector, and release it from the clip on the side of the electronics module.

6*12 Removal￿and￿Replacement

C4699*90000