Removing the Drive&Belt Pulley
1Remove the encoder strip.
U T I O N
In the following step take care not to break the black plastic tab on top of the motor.
2Press the carriage motor towards the left and remove the belt from the motor shaft.
If you need greater maneuverability of the motor, press the black plastic tab on top very slightly downwards.
B
A
Reassembling: Make sure the belt is correctly positioned on the shaft grooves.
3On the left of the plotter remove the belt from the pulley.
Reassembling: Make sure the belt is correctly positioned on the pulley grooves.
4Underneath the left side of the chassis beam release the black plastic clip and push the pulley shaft upwards.
5Remove the pulley shaft and bushing from the plotter.
6&40 RemovalandReplacement | C4699&90000 |