Printing the Plot
1Before printing the plot:
In service mode 2 set the Media Type and Print Quality on the front panel to the settings that you want to test.
In Normal mode set the Media Type and Print Quality on the front panel to the settings that you want to test.
The print.quality plot can be plotted without the need to enter the service mode. This is because the customer will be requested to plot the print.quality plot and he will be given the following instructions to plot it without entering the service mode.
2Load a sheet of media in portrait orientation.
Use E/A0.size or D/A1.size media if you want to examine vertical.line straightness (VLS) at both ends of the roller. Otherwise, A/A4.size media is sufficient.
3When the Ready LED lights up:
Press | |
Press the Print Quality and Roll/Sheet keys together. | |
Media Print
Type Quality
Plot
Ready
Ready
Print Roll/Sheet
Quality
The Ready light begins to flash, and the media moves slightly forward. The carriage moves to the right side of the plotter, and the fan turns on. The plotter plots the print.quality plot and ejects the media.
4Unload the media.
5At the end of the plot mark which print1quality setting you used.
For Example: | j Fast j Normal n Best |
Interpreting the Plot
See ' page 816 w Print.Quality Troubleshooting.
8146 Troubleshooting | C4699190000 |