Paper + Error + Film + Ready: Failure of centronics READ.
Firmware error or faulty electronics module.
Steady1349
Steady1356
Steady1357
Steady3456
Steady12345
Steady13456
Paper + Error + Fast + Load Media: Error in X9axis encoder quadrature
D Incorrect routing of the motor cables.
D Electrical noise in motors. D Faulty motor encoder. D Motor received an electrostatic discharge while operating.
Paper + Error + Fast + Special: Contents of the EEROM have been lost.
D Perform the electrical test. If it fails, the main PCA is faulty.
D Don't rule out the fact that any new service test that you perform may corrupt the EEROM.
For more information ' page 8927, w EEROM Errors.
Error + Film + Fast + Load Media: Error in encoder9strip quadrature (carriage axis). Possible causes are:
D Incorrect routing of the motor cables.
D Trailing cable is faulty or badly connected. D Faulty carriage. D Motor received an electrostatic discharge while operating.
Paper + Cartridges + Error + Film + Fast: Cartridge9alignment firmware error. Try one or more of the following:
D Turn the plotter off, and then on again to see if the problem disappears. D Ensure that the cartridges are correctly seated. D Replace cartridges.
D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report.
Paper + Error + Film + Fast + Load Media: Error in bail9lift mechanism. The bail9lift system is unable to raise or lower the bail. (It is the carriage that tests to see whether the bail is in the correct position by trying to knock against it.)
D Check the bail9lift system to see if it is working correctly. D Use the bail cycle test to help troubleshoot.
For more precise troubleshooting ' page 8919, w System Errors.
8912 Troubleshooting | C4699990000 |