Ink Spilling
The service configuration plot gives an estimation of the amount of ink in the plotter's spittoon. (Details ' page 8449 or 8450.) To prevent ink spilling, replace both the spittoon and the ink4separator when the spittoon is almost full. About 880 primes are needed to fill up the ink4separator.
Note that if you clear the EEROM or replace the electronics module, the factory spittoon value is reset to 0% used. Keep in mind that the value printed on the service configuration plot may greatly underestimate the amount of ink in the spittoon. Future PC4based plotter diagnostics will enable you to download information from the old EEROM and upload it to the new EEROM.
Belt Swelling
To prevent new belts from swelling incorrectly, keep them in their bags with dissicant until you need to install them.
Cleaning the Roll4feed Assembly
Always clean the rubber diverter of the roll4feed assembly with a dry cloth. Never clean it with water or alcohol based substances.
C4699490000 | PreventiveMaintenance 443 |