Removing the Trailing Cable

1Remove the right end'cover ' page 6'10.

2Disconnect the trailing cable from the connector marked P1 on the main PCA￿ and from the guides on the right bracket.

C

C

D

B

A

3Move the carriage out of the service station.

4Release the two indicated clips on the top of the cartridge carriage by pulling them slightly outwards.

W ￿ R N I N G

In the following step￿ take care neither to cut yourself on the encoder strip￿ nor to damage the strip￿

For DesignJet 230 only, it is also necessary to  release two clips at the bottom of the cartridge

carriage.

6'34 Removal￿and￿Replacement

C4699'90000