9Configure the plotter with the correct model ID as follows:
Only one opportunity is given to perform this procedure and there is no indication that it was successful.
If the plotter is to be configured as a DesignJet 350C (Color) plotter, hold the ALT key down and press the two
Color Configuration keys at the same time.
ALT
Color
Configuration
If the plotter is to be configured as a DesignJet 330 (Monochrome) plotter, hold the SHIFT key down and press the two
Mono Configuration keys at the same time.
Shift
Mono
Configuration
10Turn the plotter OFF.
11Reconnect the media motor encoder cable to the main PCA (connector ENC X).
12Turn the plotter ON and print the Demo Plot to check if the plotter has been correctly configured.
If the plotter is still incorrectly configured, repeat the model ID configuration procedure from step 2.
13Because all plotter calibrations are reset during the model ID configuration procedure, the plotter must be recalibrated. To perform the accuracy calibration ' page 748.
C4699490000 | Troubleshooting 8429 |