Service Configuration Plot for the DesignJet 330 and 350C

The service c￿￿figurati￿￿ pl￿t c￿￿tai￿s the f￿ll￿wi￿g i￿f￿rmati￿￿:

DesignJet 330/350C Service Configuration Plot

Firmware Release: X.XX.XX

SPROC release: X.X (Servo-Processor Code revision number.)

EEROM Contents

EEROM CONTENTS

(This is for the plotter design engineers to interpret.)

NOTE: All EEPROM Parameters are since last EEROM Reset.

Number of Power Cycles: (Number of times plotter has been switched on.)

Number of Color Plots:

Number of Black Plots:

Number of Pens: (Number of times each cartridge has been replaced. Cyan, Magenta, Yellow, Black.)

Factory Spittoon: (The estimated level of ink in the spittoon. Incorrect if you have cleared the EEROM.) Number of Bail Errors:

Number of System Errors:

Last System Error: (To correctly interpret this information, refer to page 8-23.)

Last System Error Data: (To correctly interpret this information, refer to page 8-23.)

Bench Run: (Whether the bench run has been performed.)

Bench Run Maximum Y-Axis(Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.)

Bench Run Maximum X-Axis(Media-Axis) PWM: (This should be less than 65. Typical value = 52.)

Encoder-Tests Maximum Y-Axis(Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.)

Encoder-Tests Maximum X-Axis(Media-Axis) PWM: (This should be less than 65. Typical value = 52.)

X-axis Calibration:

8￿50 Tr￿ublesh￿￿ti￿g

C4699￿90000