What You Should See and Hear

The sequence given below is what should happen when you turn on the plotter in normal operating mode.

￿ ￿ U T I O N

To observe movement of internal mechanisms￿ you can keep the cover

 

switch pressed￿ while the cover is open. However￿ in doing so￿ do not

 

block the path of the cartridge carriage with anything you stick into

 

the cover,switch area.

 

 

 

 

 

 

 

The possible states of any LED are:

Off

 

On

 

 

 

Flashing

? Can be On or Off

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 









1All front,panel LEDs flash together twice; the second flash is very short.

2If a firmware ROM SIMM is installed in the plotter￿ the following will occur:

The LEDs light up one by one as follows￿ until eight LEDs are on. This happens three times.

The LEDs light up one by one as follows￿ until all nine LEDs are on. This happens several times throughout the initialization procedure.

C4699,90000

Troubleshooting 8,￿￿