There must be no space between the entry platen and the left side￿plate. It doesn't matter if there is a small space between the entry platen and the right side￿plate.

6Replace the indicated screw on the left+hand side. (Long dog+point screw.) Tighten this screw, making sure that the entry platen is aligned tight against the left side+plate.

Torx-15

1

7Replace the indicated screw on the right+hand side. (Long dog+point screw.)

Torx-15

2

8Replace the indicated clamping screw on the left+hand side.

Torx-20

3

9Reconnect the media+sensor cable to the main PCA (connector labeled MEDIA).

10Before reinstalling the overdrive enclosure, ensure that both flags on the media sensor move freely when you pass a sheet of media over them.

6+50 Removal￿and￿Replacement

C4699+90000