Steady356
Steady368
Steady1234
Steady1238
Steady1345
Steady1346
Error + Fast + Load Media: Problems in movement in the X8axis (media axis)
The possible causes could be: D Something is causing too much friction in the
Error + Load Media + Normal: Error in X8axis calibration
Did you load media in correct orientation? D Are the marks visible on the plot? If not, check cartridges. D Are cartridges correctly aligned? If so, the problem may be in the electronics module, media motor or drive8roller gear; if alignment is incorrect, the problem may be in the carriage. There could also be a problem with the line sensor.
Paper + Cartridges + Error + Film: Communication broken between the two processors on the main PCA.
Replace the electronics module.
Paper + Cartridges + Error + Normal: Electrical error
The possible causes could be: D Missing or badly seated cartridge. D One end of the trailing cable is not connected or is badly connected, or the trailing cable is faulty. D Faulty fan, or fan is disconnected. D Faulty carriage PCA.
D Faulty electronics module.
For more precise troubleshooting ' page 8819, w System Errors.
Paper + Error + Film + Fast: Not enough memory for the sensor data structure.
D Turn the plotter off, and then on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report.
Paper + Error + Film + Load Media: Problems in the free movement of the carriage.
The possible causes could be: D Something is causing excessive friction in the Y8axis (carriage axis). D The carriage touches the bail as it moves.
See also error code Steady 346.
C4699890000 | Troubleshooting 8811 |