Error LED On
Error + Film: From firmware revision A.01.04 onwards, this combination of LEDs indicates an error in the EEROM.
See Steady 135.
Steady34
Steady38
Steady123
Error + Normal: Not enough memory to allocate internal data structures.
D Turn the plotter off, and then on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report.
Paper + Cartridges + Error: Processor fault.
Replace the electronics module.
Steady135
Steady136
Paper + Error + Fast: Error detected in the EEROM.
The possible causes could be: D Power failure during the tests. D Faulty carriage PCA. D Faulty or badly connected trailing cable. D Faulty electronics module. D Plotter is operating very near to powerful electrical motors or machines.
For more information ' page 8<27, w EEROM Errors.
For more precise troubleshooting ' page 8<19, w System Errors.
Paper + Error + Load Media: Servo error in the X<axis (media axis). Try one or more of the following:
D Clear any binding due to a media jam. Caution: Do not pull media along the carriage axis - you could break the media<sensor flags.
D Perform the media<axis test and the servo/encoder test to check for problems with the media motor and encoder, and the electronics module.
D The media<motor worm and the right drive<roller gear should have grease on them. (Parts: Silicon grease: C3190<60155) D If necessary, remove the right drive<roller gear from the drive roller. Then, if you cannot manually spin the roller, it is probably jammed. D Is the plotter located in an environment of high temperature and humidity? Is this causing deformation (flattening) of the pinch<wheels? D Replace the media motor. D Replace the electronics module.
For more precise troubleshooting ' page 8<19, w System Errors.
C4699<90000 | Troubleshooting 8<9 |