Removing the Pinch'Arm Sensor Removing the Drive'Roller Gear
1 | Remove the spittoon ' page 6'24. | 1 | Remove the spittoon ' page 6'23/6'24. |
2 | Release the pinch'arm sensor cable from | 2 | Remove the two screws that secure the |
| the indicated clip on the spittoon. |
| drive'roller gear to the drive'roller shaft. |
3 Remove the drive'roller gear from the drive'roller shaft.
The gear may be stiff.
3Gently press the two indicated tabs to the side and lift the pinch'arm sensor from the spittoon.
Reassembling: The worm pinion and drive#roller gear mesh slightly during use. Don't install a new motor and an old gear, or vice versa: install the gear that comes with the motor. Apply the grease that comes with the new motor to the worm pinion and drive#roller gear.
Reassembling: Push the gear onto the shaft as far as it will go. Align the holes on the gear with the holes on the shaft.
Always calibrate the X#axis after reassembling the motor or the gear ' page 7#8.
C4699'90000 | RemovalandReplacement 6'25 |