Steady1389
Steady2345
Steady13459
Steady12345
Plain + Error + Normal + Roll: Firmware failure (generic).
D Turn the plotter off, and then on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your
HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report.
For more precise troubleshooting ' page 8523, w System Errors.
Load Media + Error + Film + Fast : Error in Y5axis encoder quadrature (Carriage axis). Possible causes are:
D Broken or damaged encoder strip.
D Incorrect routing of the motor cables.
D Electrical noise in motors. D Faulty motor encoder. D Motor received an electrostatic discharge while operating.
Plain + Error + Film + Fast + Roll: Cartridge5alignment firmware error. Try one or more of the following:
D Turn the plotter off, and then on again to see if the problem disappears. D Ensure that the cartridges are correctly seated. D Replace cartridges.
D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report.
Plain + Load Media + Error + Film + Fast: Error in bail5lift mechanism. The bail5lift system is unable to raise or lower the bail. (It is the carriage that tests to see whether the bail is in the correct position by trying to knock against it.)
DCheck the bail5lift system to see if it is working correctly D Use the bail cycle test to help troubleshoot.
For more precise troubleshooting ' page 8523, w System Errors.
8518 Troubleshooting | C4699590000 |