10Move the carriage back into the service station.
11Close the top cover.
To adjust the carriagetomedia distanceYou will need to adjust the carriage)to)media distance if:
The ledge on the carriage did not pass over the GO side of the gauge. This means that the carriage is positioned too close to the drive roller.
The ledge on the carriage did pass over the NO GO side of the gauge. This means that the carriage is positioned too far from the drive roller.
Adjust the carriage)to)media distance as follows:
1Release the two indicated clips on the top of the cartridge carriage by pulling them slightly outwards.
W R N I N G
Take care neither to cut yourself on the encoder strip nor to damage the strip
2Pull the top of the carriage up.
C4699)9 | CalibrationsandAdjustments 7)1 |