Otherwise if the plotter is using firmware from the inbuilt ROM the following will occur:
The LEDs light up one by one as follows until eight LEDs are on. This happens three times.
The LEDs light up one by one as follows until all nine LEDs are on. This happens several times throughout the initialization procedure.
3 The front)panel LEDs indicate the current selections for Media Type and Print Quality. | |
4The cartridge carriage moves across the plotter and knocks three times against the right)hand side.
5The carriage returns to the left)hand side and enters the service station. The bail jerks slightly as the carriage parks in the service station.
6The top of the drive roller rotates slightly forward and then slightly backward.
7The carriage moves out of and back into the service station. Again the bail jerks slightly as the carriage parks in the service station.
8The plotter ejects any sheet that is already loaded. Does not eject roll media if loaded.
8)4 Troubleshooting | C4699)90000 |