3Tighten or loosen the indicated screw on the carriage. This will adjust the carriage angle on the slider rod thus increasing or decreasing the carriage%to%media distance.
Rotating
Clockwise
Gap
Increases
4Check the carriage%to%media distance ' page 7%11.
5Reinstall the top of the carriage.
6Check the trailing cable to make sure that it is positioned under the plastic tabs at the back of the carriage cover and not above them.
Trailing cable under tabs !
Otherwise the plotter will not be able to load media.
7%14 CalibrationsandAdjustments | C4699%90000 |