Removing the Right Bracket

1Remove the encoder strip ' page 6-17.

2Remove the screw that attaches the right bracket to the plotter chassis.

Torx-20

Reassembling: Use the long screw. Threaded length 3 cm (1.2 inch).

3Pull the right bracket to the right, and remove it from the plotter,

Reassembling: Insert the right"bracket tab into the slot on the right of the trailing"cable guide.

Removing the Carriage Motor

1Remove the right bracket ' page 6-21.

2Disconnect the carriage-motor cable from the main PCA (connector MOT Y), and from the clip at the back of the plotter.

￿￿ U T I O N

In the following step, take care not to break the black plastic tab on top of the motor.

3Press the carriage motor towards the left, and remove the belt from the motor shaft.

If you need greater maneuverability of the motor, press the black plastic tab on top very slightly downwards.

B

￿

C4699-90000

Removal￿and￿Replacement 6-21￿