Chapter 11

Problem with printer preparation

Solution: Check the print quality of the current print job. If it is not satisfactory, it could mean the internal clock failed and the product was not able to service the print head as scheduled. Try cleaning the print head to see if that improves the quality.

For more information, see:

Clean the print head” on page 64

Cause: The product was turned off improperly.

Sensor issue

Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.

Solution 1: Clean the sensor

Solution 2: Clean the sensor windows on the ink cartridges

Solution 3: Contact HP support

Solution 1: Clean the sensor

Solution: Clean the sensor.

If the problem is not resolved, printing can continue, but the ink system behavior might change.

CAUTION: The cleaning procedure should take only a few minutes. Make sure that the ink cartridges are reinstalled in the product when instructed. Leaving them outside of the product for an extended period of time can result in damage to the ink cartridges.

To clean the sensor in the product

1.Gather swabs or a lint-free cloth to use for the cleaning procedure.

2.Make sure the product is turned on.

3.Open the ink cartridge access door by lifting from the front right of the product, until the door locks into place.

Troubleshooting

190 Troubleshooting

Page 191
Image 191
HP D5400 manual Problem with printer preparation, Sensor issue