Assembling Your Tilt-Head Mixer

OffOn

To Attach Bowl

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Unlock motor head.

4.Tilt motor head back and lock.

5.Place bowl on bowl lock plate.

6.Turn bowl gently in clockwise direction.

7.Lower motor head and lock.

8.Plug into a grounded 3 prong outlet.

To Remove Bowl

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Unlock motor head.

4.Tilt motor head back and lock.

5.Turn bowl in counterclockwise direction and remove.

6.Lower motor head and lock.

To Attach Flat Beater, Wire Whip, or Dough Hook

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Unlock motor head.

4.Tilt motor head back and lock.

5. Slip beater

onto beater

 

 

parts

 

 

ving

 

 

remo

 

 

gof

 

 

foreinsertin

shaft and

 

0

gbe

 

nplu

 

1

N:U

 

8

UTIO

 

6

CA

 

4

 

Stir

2

 

 

 

press upward

Off/O

 

 

 

 

 

as far as

 

 

Pin

possible.

 

 

 

 

 

6.Hook beater over pin on shaft by turning clockwise (right).

7.Unlock motor head and lower.

8.Lock motor head and plug into a grounded 3 prong outlet.

To Remove Flat Beater, Wire Whip or Dough Hook

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Unlock motor head.

4.Tilt motor head back and lock.

5.Press beater upward as far as possible and turn counterclockwise (left) to unhook.

6.Pull beater from beater shaft.

7.Unlock motor head and lower.

To Lock Motor Head

1.Push locking lever back as far as possible.

2.Test lock by attempting to raise or lower head.

NOTE: Motor head should always be locked when using mixer, and when attaching or removing the bowl, flat beater, wire whip, or dough hook.

When in locked position, lever may not extend all the way back. This is normal.

To Unlock Motor Head

1.Pull locking lever forward as far as possible. Motor head can now be raised or lowered.

5

Page 7
Image 7
KitchenAid 400 manual Assembling Your Tilt-Head Mixer