User Configuration | Sets the user names and passwords for system access. |
TFTP Download | Downloads new version of firmware to update your system |
| |
Configuration File | Saves or restores configuration data based on the specified file. |
1.Only display when intelligent switch is set to Layer 2 mode or the switch is management model.
3.5.1.Changing the Network Configuration (Layer 2
Mode)
Use the Network Configuration menu to set the bootup option and configure the switch’s IP parameters. The screen shown below is described in the following table.
Parameter | Description |
IP Address | IP address of the switch you are managing. The system supports |
| SNMP over UDP / IP transport protocol. In this environment, all |
| systems on the Internet such as network interconnection devices and |
| any PC accessing the agent module (or running View) must have an |
| IP address. |
| Valid IP addresses consist of four numbers, of 0 to 255, and separated |
| by periods. Anything outside this format will not be accepted by the |
| configuration program. |
Subnet Mask | Subnet mask of the switch. This mask identifies the host address bits |
| used for routing to specific subnets. |
Gateway IP | Gateway used to pass trap messages from the system’s agent to the |
| management station. Note that the gateway must be defined (when |
| operating at Layer 2) if the management station is located in a different |
| IP segment. |
115
