LevelOne GSW-2600TXM manual Device Control Menu

SNMP Configuration	Activates authentication failure traps; configures community
	access strings, and trap managers.
User Configuration	Sets the user names and passwords for system access.
TFTP Download	Downloads new version of firmware to update your system
	(in-band).
Configuration File	Saves or restores configuration data based on the specified file.
Device Control Menu
System Mode³	Sets the switch to operate as a Layer 2 switch or as a multilayer
	routing switch.
Layer 2 Menu	Configures port communication mode, mirror ports, port
	trunking, and static addresses.
Bridge Menu	Configures GMRP and GVRP for the bridge, as well as
	Spanning Tree settings for the global bridge or for specific
	ports.
VLAN Menu	Configures VLAN settings for specific ports, and defines the
	port membership for VLAN groups.
IGMP Snooping	Configures IGMP multicast filtering.
Configuration¹
IP Menu²	Configures the subnets for each VLAN group, global
	configuration for ARP and ARP proxy, unicast and multicast
	protocols, BOOTP / DHCP relay, static ARP table entries, static
	routes and the default route.
Security Menu	Configures MAC and IP address filtering. And configures the
	learning function and Uplink port.
Network Monitor Menu
Port Statistics	Displays statistics on port traffic, including information from the
	Interfaces Group, Ethernet-like MIB, and RMON MIB.
Layer 2 Address Table	Contains the unicast address table.
Bridge Menu	Displays Spanning Tree information for the overall bridge and
	for specified ports.
VLAN Menu	Displays dynamic port registration information for VLANs as
	well as VLAN forwarding information for static and dynamic
	assignment.
IP Multicast	Displays all the multicast groups active on this switch, including
Registration Table¹	the multicast IP addresses and corresponding VLANs.
IP Menu²	Displays all the IP subnets used on this switch, as well as the
	corresponding VLANs and ports. Also contains the ARP table,
	routing table, multicast table, and OSPF table.
Restart System	Restarts the system with options to restore factory defaults.
Exit	Exits the configuration program.

1.Only display when intelligent switch is set to Layer 2 mode or the switch is management model.

2.Only display when intelligent switch is set to multilayer mode.

15