priority, or highest Router ID in case of a tie (chapter 2,3 “Configuring OSPF”).
Area Border Router – An Area Border Router (ABR) must be configured between each area and the backbone. An ABR should be configured with an IP interface that connects directly to both the backbone and the area on which it borders (chapter 2,3 “Adding an IP Interface”). However, if an area is not physically connected to the backbone, you can configure a virtual link that crosses a neighboring area to reach the backbone. Just define an ABR (i.e., virtual neighbor) on the boundary between the isolated area and transit area, as well as an ABR on the boundary between the transit area and the backbone. An ABR can be situated between one or more areas, but we advise limiting the maximum number of areas supported by a single ABR to three. You can also define a virtual link as a backup path between an ABR and the backbone.
Area Range – An ABR maintains a separate routing table for each area to which it is attached, and sends routing summaries for each attached area to the backbone, which in turn distributes this information to other areas in the autonomous system. This reduces the size of the routing tables that have to maintained throughout the system, and prevents frequent updates from flooding the system whenever a link change occurs. To configure a routing summary, you must define the OSPF Area Range for all the networks within an ABR’s area. This range is specified with an IP address and network mask (chapter 2 “OSPF Area Configuration” or chapter 3 “OSPF Area Range Configuration”). Moreover, since OSPF supports Variable Length Subnet Masks (VLSMs), you can specify a mask on a bit boundary, which can further reduce the number of advertised addresses.
Autonomous System Boundary Router – An Autonomous System (AS) contains all the routers in your network, each of which shares information with other routers to determine a
An ASBR will generate external link advertisements on selected interfaces if OSPF is enabled globally (chapter 2 “Protocol Configuration”), and any of the following conditions exist on an interface:
•RIP is enabled (chapter 2 “Adding an IP Interface” or chapter 3 “Adding an IP Interface”), or
•RIP and OSPF are both disabled (chapter 2 “Adding an IP Interface” or chapter 3
“Adding an IP Interface”).
Link State Advertisements – Each router maintains a link state database that contains information received from all the other routers within the same area (chapter 2 “Displaying the Interface Table” or chapter 3 “Displaying the Interface Table”). There are
181