Out Octets | The total number of octets transmitted out of the interface, including |
| framing characters. |
Out Unicast Pkts. | The total number of packets that |
| transmitted to a |
| were discarded or not sent. |
Out | The total number of packets that |
Pkts. | transmitted to a non- unicast (that is, a |
| |
| or not sent. |
Out Discards | The number of outbound packets which were chosen to be |
| discarded even though no errors had been detected to prevent their |
| being transmitted. One possible reason for discarding such a packet |
| could be to free up buffer space. |
Out Errors | The number of outbound packets that could not be transmitted |
| because of errors. |
CRC Errors | Number of Ethernet Cyclic Redundancy Check errors detected by |
| this device. |
|
|
Single Collisions | The number of successfully transmitted frames for which |
| transmission is inhibited by exactly one collision. |
Deferred | A count of frames for which the first transmission attempt on a |
Transmissions | particular interface is delayed because the medium was busy. |
Excessive | The number of frames for which transmission failed due to excessive |
Collisions | collisions. |
Drop Events | The total number of events in which packets were dropped due to |
| lack of resources. |
Octets | Number of octets passing through this port. |
Multiple Collisions | A count of successfully transmitted frames for which transmission is |
| inhibited by more than one collision. |
Late Collisions | The number of times that a collision is detected later than 512 |
| |
Carrier Sense | The number of times that the carrier sense condition was lost or |
Errors | never asserted when attempting to transmit a frame. |
Fragments | The total number of frames received that were less than 64 octets in |
| length (excluding framing bits, but including FCS octets) and |
| contained either an FCS or alignment error. |
Jabbers | The total number of frames received that were longer than 1518 |
| octets (excluding framing bits, but including FCS octets), and |
| contained either an FCS or alignment error. |
Note: |
|
Statistics are refreshed every 10 seconds by default (chapter 3 “Configuring the Serial Port”).
